Basic Line Editing Commands - Enterasys X-Pedition 2000 Getting Started Manual

When you are in Configure or Enable mode, use the exit command or press Ctrl+Z to exit to the
previous access mode.
Note: When you exit Configure mode, the CLI will ask you whether you want to activate the
configuration commands you have issued. If you enter yes or y, the configuration
commands you issued are placed into effect and the XP-2000's configuration is changed
accordingly. However, the changes are not written to the Startup configuration file in the
XP-2000's boot flash and therefore are not reinstated after a reboot. See Activating
Configuration Changes and Saving the Configuration File
about saving configuration changes.

Basic Line Editing Commands

The CLI supports EMACs-like line editing commands. The following table lists some commonly
used commands. For a complete set of commands, see the The TeraLink 2000 Series Library: User
Reference.
Table 21. Some commonly used CLI commands
Key sequence
Ctrl+A
Ctrl+B
Ctrl+D
Ctrl+E
Ctrl+F
Ctrl+N
Ctrl+P
Ctrl+U
Ctrl+X
Ctrl+Z
Enterasys X-Pedition 2000 Getting Started Guide
Move cursor to beginning of line
Move cursor back one character
Delete character
Move cursor to end of line
Move cursor forward one character
Scroll to next command in command history (use the cli show history
command to display the history)
Scroll to previous command in command history
Erase entire line
Erase from cursor to end of line
Exit current access mode to previous access mode
Starting the Command Line Interface
on page 60
Command
for information
45