To Transmit An Anycall - Motorola MICOM-2ES Owner's Manual

MICOM-2ES/2RS/2TS ALE Supplement to Owner's Guide
•
Double selective: similar to selective, except that you specify the last two
characters of the address.
To make an AnyCall, first you must select the address to be used for the call.
MICOM-2 will wait for responses for a certain time before entering the link state
with all the stations that responded within this interval (the maximum number of
stations that are accepted in an AnyCall is 16).
Note

To transmit an AnyCall:

1. Press CALL
The radio displays the last called address.
If you see the address you want (that is, you want to
repeat the last AnyCall), skip directly to Step 10
below, otherwise continue as explained below.
2. Press MORE
3. Press MULT
calls.
4. Press ANY
5. Press SEL
Note
_________________________________________________________________________________________________
42
Before starting, you may want to select a different net to use: see
instructions on page 24.
When MultiNet is enabled, you will be prompted for a net number
as soon as you press
(F1).
once.
(F1) to display the first page of special
(F4).
(F4).
If you try to send
address, your attempt is rejected and you see for a few seconds
NOT PROG.
CALL (F1) to start a call.
(SEND (F1)) the call without first selecting an
MOTOROLA
CALL
1001
SEND PAGE CHAN MONs
MOTOROLA
CALL
1001
MULT PAGE CHAN MONs
MOTOROLA
CALL
ALL NET GRP ANYs
MOTOROLA
CALL
ANY
SEND PAGE CHAN SELs
MOTOROLA
ALL
ENDING:_
? PAGE CHAN MONs