MICOM-2ES/2RS/2TS ALE Supplement to Owner's Guide
Transmitting Calls in ALE Mode
To transmit an ALE call, you must specify the destination. In general, the destination
consists of a net and one or more stations (members of the specified net):
When the MultiNet function (page 12) is disabled, the destination net is always
the currently selected net (its number is displayed on the LCD while the radio is
scanning). Therefore, if you do not want to select a different net, you can skip
directly to the selection of the destination station(s).
When the MultiNet function is enabled, first you must always select a net and
then the destination station(s).
To expedite the transmission of an AllCall, you can send a global AllCall by pressing
key for a few seconds.
MICOM-2 stores the last called address, so you can simply press the PTT twice in
rapid sequence (double pressing) to call again that address. This also applies to
AllCall, and therefore after sending AllCall for the first time, you can send it again
by double pressing the PTT.
Selecting the Desired Net
To select a net:
The radio displays current active net number,
2. To change the currently used net, press the
keypad, and then press ENTER.
If you want to monitor the call set up process on the speaker and
be alerted by a beep when the link is set up, turn the monitor on,
keys, or enter the net number on the