Entering The Ale Mode; Enabling The Ale Mode; Ale And Rx Only Or Tx Only Channels; Ale Programming - Motorola MICOM-2ES Owner's Manual

MICOM-2ES/2RS/2T

Entering the ALE Mode

To use the ALE mode, first it must be enabled as explained below.

Enabling the ALE Mode

To enter the ALE mode:
1. Press MENU
Note
2. Press ALE
The last active net flashes in the display.
3. To use the displayed net, press ENTER.
To select another net:
•
Press the
•
Use the keypad to enter the desired net number.
The new net number blinks, indicating that the
selection has not yet been confirmed.
4. Press ENTER
then starts scanning the channels in the selected net
(the changing channel number appears to the right
of the net number).

ALE and Rx Only or Tx Only Channels

The radio will prevent users from performing calls on Rx only or Tx only channels.
This is true even when operating in the Channel mode: when selecting a Rx Only or
Tx Only channel, the ALE option is disabled (the
when such a channel is selected).

ALE Programming

ALE supports many features, including:
•
Various type of calls
•
Up to 20 nets, each with its own set of members and associated frequencies
(channels)
_________________________________________________________________________________________________
14
S ALE Supplement to Owner's Guide
to display the Menu screen.
If you see SCAN
enable the ALE functionality using
PROG>RAD>OPTS>ALE.
(F3).
UP/DOWN keys until you reach the required number.
or
to confirm your choice. The radio
next to F3, first
CALL
MOTOROLA
MENU
CHAN FREQ
MOTOROLA
ALE
NET 7
MOTOROLA
ALE
NET 1
MOTOROLA
ALE
NET 1
CALL LQA
(F1) key is not displayed
ALE BITs
1
MON