Replacing The Current Channel While In The Link State; To Replace The Channel; Pwr; Agc - Motorola MICOM-2ES Owner's Manual

PWR

(MORE, MORE, F1)
MODE
(MORE, MORE, F2)

AGC

(MORE, MORE, F3)
BW
(MORE, MORE, F4)
RCLV
(MORE, MORE,
MORE, F1)
FREQ
(MORE, MORE,
MORE, F2)

Replacing the Current Channel While in the Link State

If during an individual call you find that the channel in use is not good enough, you
can replace it with a better channel.
Note

To replace the channel:

1. Press MORE
2. Press RPL
3. The radio disconnects the link, replaces the channel being used, and initiates
the call once again.
Note
_________________________________________________________________________________________________
selects the transmit power level (LOW, MED, HIGH or
MAX).
selects the operation mode (SSB, AME or PLT).
controls the automatic gain control function (fast/slow/off).
selects the filter bandwidth,
displays the receive level while F1 is pressed.
displays the current frequency while F2 is pressed.
•
Channel replacement is possible only during an individual
call in the ALE mode.
•
Only the initiator of a call can replace the channel in use.
to scroll to the second link state menu.
(F1) to replace the channel in use.
Even if a message was transmitted when the original link was
initiated, the new link will be initiated without the message.
MORE
MORE
New ALE Features
21