MICOM-2ES/2RS/2TS ALE Supplement to Owner's Guide
To define or change a group:
1. Press CALL (F1) and select the GRP option, as you do to start a group call
2. The first group displayed is always group 1. If this
is the group you want, skip directly to Step 3 below,
otherwise press the UP or DOWN arrows until you
see the desired group.
3. To select the stations you want in this group, press
4. After pressing
screen. Therefore, you can select stations from the
addresses already stored in the directory, or type
new addresses using the keypad.
To select an address from these already in the directory:
Use the UP and DOWN arrows to display the desired directory entry,
and then press
The label above the selected entry changes to
ADDED, to indicate that it is now included in
Now you can also have the option
to delete the entry from the group.
Repeat the procedure described above until the
group includes only the desired stations.
The following example explains how to build a new group, but you
can use the same procedures to change an existing group.
(F4), you will see the DIR
If adding the station would cause the
total length of the station addresses in
the group to exceed 12 ALE words, then
BUFF FULL and the process stops.
(F1) you will see