Motorola MICOM-2ES Owner's Manual page 57

6. Select the AnyCall address:
•
To send a general AnyCall, press
•
To send a selective AnyCall, enter the desired
character (any character except #, @ or ?).
•
To send a double-selective AnyCall, enter two
characters.
7. Confirm your selection by pressing ENTER (see below examples for the 3
types of addresses).
MOTOROLA
CALL
ANY ?
@@
SEND PAGE CHAN
8. Press PAGE
9. Press CHAN
Press SEND
AnyCall process. During this process, you will see TO alternating with the
number of the channel on which the request is being sent.
Note
When an AnyCall is transmitted, the initiator of the
call receives an indication of each station answering
the call (its address flashes in the display, until
replaced by the next answering station).
10. After a programmed interval (or after 16 stations
answer, whichever comes first), the link is
established. Now you can start talking.
11. To end the call, press ESC.
_________________________________________________________________________________________________
MOTOROLA
CALL
ANY
SELs SEND
(F2) if you want to attach a message to the call.
(F3) if you want to initiate the call on a specific channel.
(F1) or ENTER
You can press STOP
? (F1).
2
@@
PAGE CHAN SELs
to initiate the call. The radio now starts the
(F1) or ESC to abort the entire process.
New ALE Features
MOTOROLA
ALL
ENDING:_
? PAGE CHAN
MOTOROLA
ALL
ENDING:1_
? <-- CHAN
MOTOROLA
ALL
ENDING:59
? <-- CHAN
MOTOROLA
CALL
ANY 59
@
SEND PAGE CHAN
MOTOROLA
LINK
1111
MOTOROLA
LINK
ANY
SEND PAGE GLOB
MOTOROLA
END CALLING
CLR
CLR
CLR
SELs
MONs
43