This section provides concise instructions for using the ALE Programming mode.
This mode, reached under the PROG menu (see Figure 4 and Figure 5) is used to
configure the parameters needed by the ALE function. The ALE parameters are
identified in Figure 5.
After locating the required ALE parameter in the Programming menu, you can
change it by pressing the function key next to the parameter name, and then press the
keys to scroll or set parameters.
To enter the ALE Programming mode:
In the ALE Programming mode, you can program the following features (see also
The Programming mode is accessible only if the radio is not
to display the Menu screen.
to scroll to the second Menu screen.
(F2) to enter the ALE Programming
as required to access additional ALE
Net parameters: station names, options, members
and scanned channels.
Edit the list of stations not appearing in the
directory from which calls have been received.
This item is displayed only after such calls have
been received, and therefore will not appear when
the MICOM-2 is just turned on.
See Page ...