Removing An Ethernet Adapter - Lenovo THINKSERVER 3797 Hardware Maintenance Manual

2. Connect any required cables to the adapter (see "Internal cable routing and
3. Align the PCI riser-card assembly with the selected PCI connector on the
4. Press down on the assembly. Make sure that the riser-card assembly is fully
5. Perform any configuration tasks that are required for the adapter.
6. Install the server cover (see "Completing the installation" on page 227).
7. Slide the server into the rack.
8. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing an Ethernet adapter

To remove an Ethernet adapter, complete the following steps:
1. Read the safety information that begins on page 3 and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover.
4. Remove the PCI riser card 1.
5. Push the tabs on the adapter bracket 2 outwards, then lift the front end of the
6. Install the cover.
connectors" on page 163.)
Attention:
v When you route cables, do not block any connectors or the ventilated space
around any of the fans.
v Make sure that cables are not routed on top of components under the PCI
riser-card assembly.
v Make sure that cables are not pinched by the server components.
system board:
v PCI-riser connector 1: Carefully fit the two alignment slots on the side of the
assembly onto the two alignment brackets on the side of the chassis; align
the rear of the assembly with the guides on the rear of the server.
v PCI-riser connector 2: Carefully align the bottom edge (the contact edge) of
the riser-card assembly with the riser-card connector on the system board;
align the rear of the assembly with the guides on the rear of the server.
seated in the riser-card connector on the system board.
peripheral devices and the server.
on page 11.
external cables.
adapter 1 to disconnect it from the system board. Then lift it out of the server.
Chapter 6. Removing and installing FRUs
173