HP ML570 - ProLiant - G2 Setup And Installation Manual page 91

Installing Hardware Options
2. Locate and remove the Torx T-15 tool. Refer to "Locating and Removing the
Torx T-15 Tool" in this chapter.
3. Remove the power supply blank:
a. Loosen the two Torx T-15 screws on the cover protecting the available
hot-plug power supply bay, just beneath the system tray (1).
b. Slide the power supply blank up and out to remove it (2).
Figure 3-43: Removing the power supply blank from its
bay
3-50 HP ProLiant ML570 Generation 2 Server Setup and Installation Guide