3. If manual compression does not force the cage nut into place, use the fitting tool
(supplied with the rack):
a. Rest the bottom tab of the cage nut on the square cutout on the vertical post.
b. Insert the angled tip of the fitting tool through the other side of the square
cutout and hook the top tab of the cage nut.
c. Use the fitting tool as a lever to pull the cage nut into position.
Figure 5-2: Inserting cage nuts into the rack frame
4. Repeat steps 1 and 2 for a second cage nut.
HP ProLiant ML570 Generation 2 Server Setup and Installation Guide
Installing the Rack Server
5-7