To install a Remote Insight board:
IMPORTANT: Due to cabling requirements, HP recommends that you install the Remote
Insight board in slot 7.
1. Identify slot 7, the recommended slot for the Remote Insight board.
2. To install the Remote Insight board, refer to "Installing a Non-Hot-Plug
Expansion Board" in this chapter.
3. Identify the 30-pin (1) and 16-pin (2) remote management connectors and
determine which is appropriate for your Remote Insight board.
Figure 3-38: 30-pin and 16-pin remote management
connectors
HP ProLiant ML570 Generation 2 Server Setup and Installation Guide
Installing Hardware Options
3-45