HP ML570 - ProLiant - G2 Setup And Installation Manual page 115

Installing Hardware Options
5. Connect the power and signal cables to the DVD drive. Refer to the
documentation that ships with the option kit for directions on cabling the DVD
drive. For internal cabling information specific to DVD drive installation in the
server, refer to Chapter 7, "Cabling the Server."
Figure 3-65: Cabling a DVD drive from the CD-ROM drive
bay to the primary IDE connector on the system board
6. Reinstall the drive air baffle and tighten the thumbscrews.
7. Reinstall the CPU and I/O fan baskets and tighten the thumbscrews.
8. Reinstall the CPU and I/O fans.
9. Close the system tray.
10. Reinstall the access panel.
11. Install the server. Refer to Chapter 5, "Installing the Rack Server" or Chapter 6,
"Installing the Tower Server."
12. Power up the server. Refer to Chapter 5, "Installing the Rack Server" or
Chapter 6, "Installing the Tower Server."
13. Be sure that the LED on the front of the DVD drive is illuminated green, indicating
that the system is functioning properly. For detailed information on LEDs, refer to
Appendix C, "System LEDs and Switches."
14. If any of the LEDs indicates an error, refer to Appendix D, "Troubleshooting," or
refer to the troubleshooting guide for instructions.
3-74 HP ProLiant ML570 Generation 2 Server Setup and Installation Guide