Eeprom Customizing - Brother MFC5200C Service Manual

7.5.17 EEPROM Customizing

Function
This function allows you to customize the EEPROM according to language, function settings, and
firmware switch settings. The customizing codes list is given in Appendix 3.
NOTE: If you replace the driver PCB, be sure to carry out this procedure.
Operating Procedure
(1) Press the 7 and 4 keys in this order in the initial stage of the maintenance mode.
The current customizing code (e.g., 3001 in the case of MFC5200C U.S.A. versions) appears.
(2) Enter the desired customizing code (e.g., 2002 in the case of MFC5200C Canadian versions).
NOTE: To enter letters "A" through "F," press the 1 through 6 keys while holding down the #
key, respectively.
The newly entered code appears.
NOTE: If a wrong 4-digit code is entered, the equipment will malfunction.
(3) Press the Fax Start key.
The equipment saves the setting and returns to the initial stage of the maintenance mode.
If you press the Stop key or no keys are pressed for one minute in the above procedure, the
equipment stops the procedure and returns to the initial stage of the maintenance mode.
7 -2 7