Reassembling Note: When fitting the rear bushing of the document ejection roller into the
cutout of the ADF drive unit, orient the boss as illustrated on the previous page.
Document pressure bar
(7) Open the ADF & document cover ASSY.
(8) Pull either of the front and rear supports of the document pressure bar outwards and remove
the document pressure bar. The spring also comes off.
ADF & document cover ASSY
Document pressure bar
Reassembling Note: After setting the document pressure bar, check in the direction of arrow
"X" that the spring is into place as illustrated above.
Document pressure bar
Supports
Spring
Spring
"X"
6 -2 0
Setting the spring (Viewed from "X")
Correct
Wrong