Control Panel Assy - Brother MFC5200C Service Manual

6.1.8 Control Panel ASSY

(1) Remove six screws "b" from the underside of the scanner base.
(2) Slightly lift up the control panel ASSY and disconnect the panel harness from the control panel
PCB.
(3) Turn the scanner open sensor actuator as shown below and remove it.
(4) Remove screw "a" from the scanner open sensor PCB. Then the control panel ASSY is
separated from the scanner unit.
(For the disassembly procedure of the control panel ASSY and scanner unit, refer to
Subsections 6.1.9 and 6.1.10, respectively.)
(5) Remove the lever spring.
Insert the tip of a flat screwdriver into slit "s," push up the lock, and remove the scanner
release lever in the direction of the arrow.
Panel harness
Control panel ASSY
"b"
Scanner base
"a"
Scanner open sensor PCB
Lever
spring
"s"
"b"
Lock
"a": Taptite, cup B M3x8
"b": Taptite, cup B M3x12
6 -3 0
Scanner open sensor
actuator
Scanner release lever