Fg Plates, Power Supply Pcb, And Ncu Pcb - Brother MFC5200C Service Manual

6.1.16 FG Plates, Power Supply PCB, and NCU PCB

(1) Remove two screws "f" and take out the FG plate R.
(2) Remove screw "g" (two screws "g" if the scanner unit has not been removed) and take out the
FG plate L. (Through the cutout provided in the FG plate L, the paper feed motor harness and
ink empty sensor harness are routed.)
(3) Remove two screws "h."
(4) Disconnect the power supply harness from the driver PCB.
(5) Lift up the NCU/PS shield box while taking out the power supply harness from the cable
guides.
"f" and "g": Taptite, cup S M3x6
"h": Taptite, cup B M3x10
6 -4 5