Brother MFC5200C Service Manual page 113

Purge switch harness
Carriage motor harness
Head flat cable W
(driver-head signal line)
Registration sensor
Reassembling Notes
• For easier installation of the driver PCB, pull the two sensor actuators to the rear and fit corners
"X" and "Y" into/over opening "x" and pawl "y" as illustrated on the previous page.
• When reinstalling the harness support film L to the main chassis, route the head flat cable M
through the slit provided in the film L and set the flat core onto the flat cable M. Then fit the flat
core over the tab of the harness support film L. (Refer to Subsection 6.1.31 "Harness Routing
C."
• If you replace the driver PCB, be sure to follow the flowchart given on the next page.
Head flat cable N
(driver-carriage PCB)
Driver PCB
Paper width sensor
Power supply harness
6 -5 1
ADF motor/document sensor/
document cover open sensor harness
Panel harness
Main-driver connector
Ink empty sensor
harness
Paper feed motor
harness