Brother MFC5200C Service Manual page 255

Selector
No.
1
| Not used.
7
Erasure of message stored in
8
the memory after the message
transfer
Selector 8: Erasure of message stored in the memory after the message transfer
Setting this selector to "0" will erase the message recorded in the memory after the document
retrieval feature transfers the message.
Selector
No.
1 ECM* in sending
2 ECM* in receiving
3 Call Waiting Caller ID
4 Not used.
5 Acceptable TCF bit error rate
| (%)
8 (Only at 4800 bps)
NOTE: Selector 3 is applicable to the American versions only.
NOTE: Selectors 5 through 8 are applicable to the Chinese, Taiwanese and Asian versions only.
Selector 3: Call Waiting Caller ID
Setting this selector to "0" allows the user to decide whether or not to interrupt the current call
when a new call comes in. If Call Waiting Caller ID service is available in the area and the user
subscribes to it, he/she can see information about his/her incoming call on the LCD.
Selectors 5 through 8:
Setting two or more selectors to "1" produces addition of percent assigned to each selector. If you
set selectors 7 and 8 to "1," the acceptable TCF bit error rate will be 3%.
WSW21
Function
WSW22
(ECM and copy resolution setting)
Function
Acceptable TCF bit error rate (%)
App. 4-24
)
(TAD setting 1
Setting and Specifications
0: Yes
Setting and Specifications
0: ON
0: ON
0: ON
0: 0%
0: 0%
0: 0%
0: 0%
1: No
1: OFF
1: OFF
1: OFF
1: 8%
1: 4%
1: 2%
1: 1%
* ECM: Error correction mode