Brother MFC5200C Service Manual page 258

Selector
No.
1
Not used.
2
Dialing during document
reading into the temporary
3
memory in in-memory message
transmission
No. of CNG cycles to be
detected
4 (when the line is connected via
5 the external telephone except in
the external TAD mode or via
the built-in telephone)
No. of CNG cycles to be
detected
(when the line is connected via
6
the external telephone in the
7
external TAD mode or via the
facsimile equipment in F/T
mode)
8 Not used.
Selector 3: Dialing during document reading into the temporary memory in in-memory message
transmission
If this selector is set to "0," the facsimile equipment waits for document reading into the memory
to complete and then starts dialing. This enables the equipment to list the total number of pages in
the header of the facsimile message.
Selectors 4 and 5: No. of CNG cycles to be detected
The equipment interprets a CNG as an effective signal if it detects a CNG signal by the number of
cycles specified by these selectors when the line is connected via the external telephone except in
the external TAD mode or via the built-in telephone.
Selectors 6 and 7: No. of CNG cycles to be detected
The equipment interprets a CNG as an effective signal if it detects a CNG signal by the number of
cycles specified by these selectors when the line is connected via the external telephone in the
external TAD mode or via the facsimile equipment in F/T mode.
WSW26
(Function setting 4)
Function
App. 4-27
Setting and Specifications
0: Disabled 1: Enabled
No. 4 5
0 0 : 0.5
0 1 : 1
1 0 : 1.5
1 1 : 2
No. 6 7
0 0 : 0.5
0 1 : 1
1 0 : 1.5
1 1 : 2
(A)
(B)
(C)
(D)
(A)
(B)
(C)
(D)