Brother MFC5200C Service Manual page 90

(10) Remove the two screws from the bottom rear of the hinges.
(11) Be sure to open the document cover, then release the harness & grounding wire (which are
covered with a cable sheath and bound with a cable binder) from the latch and move them to
the front in the opening.
(12) Lift up the document cover.
Cable guide
Cable sheath
Opening
Latch
Cable binder
Taptite, bind B
M4x12
Panel harness
Grounding wire
(13) From the hinge base R, remove the hinge arm as shown below. Remove the three screws and
release the hinge base R.
(14) From the hinge L that should be kept opened, remove the three screws.
Document cover
Hinge L
Releasing the harness & grounding wire, covered with
a cable sheath and bound with a cable binder
Latch
Hinge
Harness (ADF motor/document sensor/
document cover open sensor)
Hinge arm
Taptite, cup B M3x10
6 -2 8
Cable sheath
Document cover
Hinge
Hinge base R
Taptite, cup B M3x10
Scanner unit