6.1.28 Ink Empty Sensor PCB
(1) Remove the screw that secures the sensor support to the main chassis if it has not been
removed in Subsection 6.1.25.
(2) Pull up the sensor support and release the ink empty sensor harness from the cable guides
provided on the underside of the main chassis.
(3) Remove the screw from the ink empty sensor PCB.
Ink empty sensor
Reassembling Notes
• Route the ink empty sensor harness through the cable guides provided on the underside of the
main chassis as illustrated above.
Ink empty sensor harness
Cable guide
Cable guide
Sensor support
6 -6 9
Ink empty sensor PCB
Taptite, cup B M3x8