Laser Unit And Toner Sensor Pcb - Brother FAX 2800 - B/W Laser - Fax Service Manual

4.1.12 Laser Unit and Toner Sensor PCB

(1) Disconnect the polygon motor flat cable, toner sensor harness, and laser diode harness from
the main PCB.
(2) Remove the three screws from the laser unit.
(3) Lift up the laser unit.
NOTE: When handling the laser unit, take care not to touch the inside of the unit, glass, or
mirror.
NOTE: On the small PCB at the right side of the laser unit is a 2-pin connector which is for
the adjustment in the factory. Do not disturb it.
n Reassembling Notes
• On the underside of the laser unit, route the laser diode harness, polygon motor flat cable, and
toner sensor harness as illustrated in Subsection 4.1.26, "Harness routing G."
• Before putting the laser unit back into place, check for any toner particles, paper dust or dirt,
and clean them out.
• Make sure that the sponge is placed below the laser unit.
4 -27