Setting The Switch-To-Client Frame-Retransmission Number - Cisco Catalyst 2960-X Security Configuration Manual

Setting the Switch-to-Client Frame-Retransmission Number

Command or Action
gigabitethernet2/0/1
Step 6
copy running-config startup-config
Example:
Switch# copy running-config startup-config
Setting the Switch-to-Client Frame-Retransmission Number
In addition to changing the switch-to-client retransmission time, you can change the number of times that the
switch sends an EAP-request/identity frame (assuming no response is received) to the client before restarting
the authentication process.
Note You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
Beginning in privileged EXEC mode, follow these steps to set the switch-to-client frame-retransmission
number. This procedure is optional.
SUMMARY STEPS
1. configure terminal
2. interface interface-id
3. dot1x max-reauth-req count
4. end
DETAILED STEPS
Command or Action
Step 1 configure terminal
Example:
Switch# configure terminal
Step 2
interface interface-id
Example:
Switch(config)# interface
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
316
Configuring IEEE 802.1x Port-Based Authentication
Purpose
(Optional) Saves your entries in the configuration file.
Purpose
Enters the global configuration mode.
Specifies the port to be configured, and enter interface
configuration mode.
OL-29048-01