Setting Basic Ip Options - NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual

Setting Basic IP Options

Enter the basic IP settings for your wireless access point on this screen. The default settings will
work in most cases. However, if your wireless access point is part of a more complex LAN
network, then modify these settings to meet the requirements of your network.
To configure the basic IP settings of your wireless access point:
1. Select Configuration > IP. The IP Settings screen will display as shown in
Figure 2-9
2. If necessary, edit the IP address fields of the WNAP210.
– DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask, and default gateway settings
automatically from the DHCP server on your network when you connect the WNAP210 to
your LAN.
– IP Address. Enter the IP address of your wireless access point. The default IP address is
192.168.0.236. To change it, enter an unused IP address from the address range used on
your LAN, or enable DHCP.
Installation and Configuration
ProSafe Wireless-N Access Point WNAP210 Reference Manual
v1.0 March 2009
Figure 2-9.
2-15