Setting Basic Ip Options - NETGEAR ProSafe WNDAP350 Reference Manual

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual

Setting Basic IP Options

The basic IP settings for your wireless access point are entered on this screen. Most of the default
settings will work in most cases. However, if your wireless access point is part of a more complex
LAN network, then modify the settings to meet the requirements of your network based on the
explanation of the various fields.
To configure the basic IP settings of your wireless access point:
1. Under Configuration, select IP, and then IP Settings. The IP Settings screen displays as
shown in Figure 2-9
Figure 2-9 Basic IP options
2. Enter the IP Address fields of the WNDAP350.
– DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is
disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless
access point will get its IP address, subnet mask and default gateway settings
automatically from the DHCP server on your network when you connect the WNDAP350
to your LAN.
– IP Address. Enter the IP Address of your wireless access point.The default IP address is
192.168.0.237. To change it, enter an unused IP address from the address range used on
your LAN; or enable DHCP.
Basic Installation and Configuration
below.
v2.0, April 2013
2-13