Troubleshooting And Debugging; No Lights Are Lit On The Wireless Access Point - NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual

This chapter provides information about troubleshooting your ProSafe Wireless-N Access Point.
After each problem description, instructions are given to help you diagnose and solve the problem.
For the common problems listed, go to the section indicated.
• Is the WNAP210 on?
Go to "Installing the WNAP210 Wireless Access Point" on page
• Have I connected the wireless access point correctly?
Go to "Installing the WNAP210 Wireless Access Point" on page
• I cannot remember the wireless access point's configuration password.
Go to "Changing the Administrator Password" on page
Note: For up-to-date WNAP210 installation details and troubleshooting guidance visit
http://kbserver.netgear.com/products/WNAP210.asp.
If you have trouble setting up your WNAP210, check the tips below.

No lights are lit on the wireless access point.

It takes a few seconds for the Power LED to light. Wait a minute and check the Power LED on the
access point.
If the access point has no power:
• Make sure that the power cord is connected to the access point.
• Make sure that the power adapter is connected to a functioning power outlet. If it is in a power
strip, make sure that the power strip is turned on. If it is plugged directly into the wall, verify
that it is not a switched outlet.
• Make sure that you are using the correct NETGEAR power adapter supplied with your access
point.

Troubleshooting and Debugging

v1.0 March 2009
Chapter 5
2-4.
2-4.
3-8.
5-1