NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual page 76

ProSafe Wireless-N Access Point WNAP210 Reference Manual
To access the System screen:
1. Select Monitoring > System view the System screen, shown in
shows the parameters listed in
Table 3-1. System Information Fields
Field
Access Point Information
Access Point Name
MAC Address
Country/Region
Firmware Version
Access Point Mode
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
Current Wireless Settings for 802.11n/g
Operating Mode
Channel/Frequency
Rogue AP Detection
3-12
Table 3-1:
Description
Indicates the NetBIOS name. The default name can be changed, if you
wish.
Displays the Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
Displays the domain or region for which the wireless access point is
licensed for use. It might not be legal to operate this wireless access point in
a region other than one of those identified in this field.
The version of the firmware currently installed.
Identifies the operating mode of the WNAP210: Access Point, Point-to-point
bridge, Point-to-point bridge with Access Point, Multi-point bridge, or
Repeater.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
Enabled indicates that the current IP address was obtained from a DHCP
server on your network. Disabled indicated a static IP configuration.
Identifies the 802.11 operating mode of the WNAP210.
Identifies the channel the wireless port is using. 11 is the default channel
setting. Channel frequencies used on each channel can be found in "Wire-
less Networking Basics"; a link to this article is in
uments".
Identifies whether the Rogue AP detection feature is enabled or disabled.
v1.0 March 2009
Figure 3-11. This screen
Appendix B, "Related Doc-
Management