Remote Console - NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual

ProSafe Wireless-N Access Point WNAP210 Reference Manual
2. Enter the following information in the SNMP fields:
• SNMP. Enable SNMP to allow the SNMP network management software, such as HP
OpenView, to manage the wireless access point through SNMPv1/v2 protocol.
• Read-Only Community Name. The community string to allow the SNMP manager to
read the wireless access point´s MIB objects. The default is Public.
• Read-Write Community Name. The community string to allow the SNMP manager to
read and write the wireless access point´s MIB objects. The default is Private.
• Trap Community Name. The community string to allow the SNMP manager to send
traps. The default is Trap.
• IP Address to Receive Traps. The IP address of the SNMP manager to receive traps sent
from the wireless access point. The default is 0.0.0.0.
3. Click Apply.

Remote Console

Remote Console configuration features are located under the Maintenance, Remote
Management, Remote Console. Enter the following information in the Remote Console screen,
as shown in Figure 3-2:
• Secure Shell (SSH). If set to Enable, the wireless access point will allow remote access only
through Secure Shell and Secure Telnet. The default is Enable.
• Telnet. If set to Enable, the wireless access point will allow remote access through Telnet. The
default is Disable. If Telnet is enabled and the access point is accessed using a browser, the
Telnet access will be disconnected.
3-2
v1.0 March 2009
Management