NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual page 96
Wireless-n access point
Hide thumbs
Also See for WNAP210 - ProSafe Wireless-N - Wireless Access Point:
- User manual (82 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
ProSafe Wireless-N Access Point WNAP210 Reference Manual
Figure 4-7
3. Configure the WNAP210 access point (AP2) on LAN Segment 2 in Point-to-Point Bridge
mode.
AP1 must have AP2's MAC address in its Remote MAC Address field, and AP2 must have
AP1's MAC address in its Remote MAC Address field.
4. Configure and verify the following parameters for both access points:
•
Verify that both access points are configured to operate in the same LAN network address
range as the LAN devices.
•
Both use the same ESSID (Extended Service Set Identification), channel, authentication
mode, if any, and security settings if security is in use.
4-12
v1.0 March 2009
Advanced Configuration
Advertisement
Table of Contents
