NETGEAR WNAP210 - ProSafe Wireless-N - Wireless Access Point Reference Manual page 63

Figure 2-23
3. Select the Turn Access Control On check box to enable the access control feature.
4. Select the access control database options. The options are:
• Local MAC Address Database. The access point will use the local MAC address table
for access control. This is the default.
• RADIUS MAC Address Database. The access point will use the MAC address table
located on the external RADIUS server on the LAN for access control. If you select this
database, you must configure the RADIUS server settings first (see
RADIUS Server Settings" on page
5. The Trusted Wireless Stations list shows any wireless stations you have entered. If you have
not entered any wireless stations, this list is empty. To delete an existing entry, select it and
click Delete.
6. Click Refresh to refresh the available wireless stations list found in your area.
7. Select the stations from the list of available wireless stations, or enter station MAC addresses
manually. (The MAC address is usually on the bottom of the wireless adapter.)
8. Click Add to add the wireless device to the Trusted Wireless Stations list. Repeat these steps
for each additional device you want to add to the list.
9. Click Apply to save your wireless access control list settings.
Now, only devices on this list will be allowed to wirelessly connect to the access point.
Installation and Configuration
ProSafe Wireless-N Access Point WNAP210 Reference Manual
2-27).
v1.0 March 2009
"Configuring the
2-41