3Com 3C10111C - NBX 100 - Modular Exp Base Installation Manual page 169

You can connect a computer directly to the serial port on these devices:
Table 25 Serial Port Connections
Card
SuperStack 3 NBX Call Processor
NBX 100 Call Processor
BRI-ST Digital Line Card
E1 Digital Line Card
T1 Digital Line Card
NBX Analog Line Card (3C10114C only)
NBX Analog Terminal Card (3C10117C only)
NBX Analog Terminal Adapter (3C10400 only)
It does not matter which computer operating system you use. As long as
the computer has a terminal emulation program that can emulate a
VT100 terminal (for example, Microsoft Hyperterminal), it can
communicate with any of the cards listed in
To connect the computer to the COM1 or CONSOLE port on a board:
1 Using a standard computer serial cable (9-pin male to 9-pin female),
connect the male end of the cable to the female connector (COM1 or
CONSOLE) on the front panel of the board.
2 Connect the female end of the cable to an available serial port on the
computer.
3 Start the terminal emulation software and create a new connection.
4 Configure the connection to use the serial port to which you connected
the cable and to use the settings in
Table 26 Terminal Emulation Program Properties
Property
Emulation
Baud Rate
Data bits
Parity
Stop bits
Flow control
Connecting a Computer to a Serial Port
Table 26.
Value
VT100
9600
8
None
1
None
Port
COM1
COM1
CONSOLE
CONSOLE
CONSOLE
CONSOLE
CONSOLE
10101
Table 25.
169