End - Agilent Technologies 3458A User Manual

END

END

Syntax
control
Remarks
Example
176 Chapter 6 Command Reference
The END command enables or disables the GPIB End Or Identify (EOI)
function.
END [control]
The control parameter choices are:
Numeric
control Query
Parameter Equiv.
OFF 0
ON 1
ALWAYS 2
Power-on control = OFF.
Default control = ALWAYS.
•
Each reading output to the GPIB in ASCII format is normally followed by cr,lf
(carriage return, line feed). The cr lf indicates the end of transmission to most
controllers. Readings output in any other format do not have the cr lf end of line
sequence. When using the ASCII output format and multiple readings are
recalled from reading memory using the RMEM command, the multimeter
places a comma between readings. In this case, the cr,lf occurs only once,
following the last reading in the group being recalled. Commas are not used
when readings are output directly to the bus (reading memory disabled), when
readings are recalled using "implied read", or when using any other output
format.
•
Check your computer manual for information on how your computer responds
to the EOI line.
•
If END ALWAYS is specified for the high-speed mode, the EOI mode
automatically becomes ON while the readings are being taken. Following
completion of the readings, the EOI mode returns to ALWAYS. Refer to
"Increasing the Reading Rate" in Chapter 4 for more information on the
high-speed mode.
•
Query Command. The END? query command returns the present EOI mode.
Refer to "Query Commands" near the front of this chapter for more information.
•
Related Commands: OFORMAT
OUTPUT 722;"END ALWAYS" !ENABLES GPIB EOI
Description
EOI line never set true
For multiple readings (SWEEP or NRDGS >1) the EOI
line is set true with the last byte of the last reading sent.
For single readings, EOI line set true with the last byte
of each reading.
EOI line set true when the last byte of each reading
sent.