Default Settings
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Tip
After configuring the VSAN interface, you can configure an IP address or Virtual Router Redundancy
Protocol (VRRP) feature (see
Creating VSAN Interfaces
To create a VSAN interface, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# interface vsan 2
switch(config-if)#
Step 3
switch(config-if)# no shutdown
Displaying VSAN Interface Information
To display VSAN interface information, use the show interface vsan command.
switch# show interface vsan 2
vsan2 is up, line protocol is up
Default Settings
Table 12-7
Table 12-7
Parameters
Interface mode
Interface speed
Administrative state
Trunk mode
Trunk-allowed VSANs
Interface VSAN
Beacon mode
EISL encapsulation
Data field size
Cisco MDS 9000 Family CLI Configuration Guide
12-40
Chapter 43, "Configuring IP
WWPN is 10:00:00:05:30:00:59:1f, FCID is 0xb90100
Internet address is 10.1.1.1/24
MTU 1500 bytes, BW 1000000 Kbit
0 packets input, 0 bytes, 0 errors, 0 multicast
0 packets output, 0 bytes, 0 errors, 0 dropped
lists the default settings for interface parameters.
Default Interface Parameters
Services").
Purpose
Enters configuration mode.
Configures a VSAN with the ID 2.
Enables the VSAN interface.
Default
Auto
Auto
Shutdown (unless changed during initial setup)
On (unless changed during initial setup)
1 to 4093
Default VSAN (1)
Off (disabled)
Disabled
2112 bytes
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 12
Configuring Interfaces