Displaying Snmp Security Information - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

SNMP Trap and Inform Notifications
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To disable SNMP link-state traps for specific interfaces, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface bay 6
switch(config-if)# no link-state-trap
switch(config-if)# link-state-trap
Whenever you disable an SNMP link-state trap for an interface, the command is also added to the
running configuration of the system. To view the running configuration, enter the show running-config
command for the interface.
switch# show running-config
version 3.1(2)
....
interface bay5
interface bay6
no link-state-trap <-----command is added to the running configuration for the interface
interface bay7
...
To view the SNMP link-state trap configuration for a particular interface, enter the show interface
command.
switch# show interface bay 6
bay6 is down (Administratively down)

Displaying SNMP Security Information

Use the show snmp commands to display configured SNMP information (see
Example 31-1 Displays SNMP User Details
switch# show snmp user
______________________________________________________________
______________________________________________________________
Cisco MDS 9000 Family CLI Configuration Guide
31-14
Hardware is Fibre Channel
Port WWN is 20:0b:00:05:30:01:70:2c
Admin port mode is auto, trunk mode is on
snmp link-state traps are disabled
Port vsan is 1
Receive data field Size is 2112
Beacon is turned off
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
0 frames output, 0 bytes
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
SNMP USERS
Chapter 31
Purpose
Enters configuration mode.
Specifies the interface on which to disable SNMP
link-state traps.
Disables SNMP link-state traps for the interface.
Enables SNMP link-state traps for the interface.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring SNMP
Example 31-1 and 31-6).