HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 56

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 1-1 New and Changed Features for Release 3.x (continued)
Feature
Removal of restrictions
on oversubscription ratios
FICON Tape
Acceleartion
IP Network Simulator
Generation 2 switching
modules
Command scheduler
remote user support
IVR zones and zone
members
RLIR messages
User configuration limit
show tech-support
command
install ssi command
Domain manager fast
restart
FICON port prohibiting
default
CLI enhancements
Cisco MDS 9000 Family CLI Configuration Guide
lvi
Description
Allows users to remove any restrictions on
maximum oversubscription ratios.
Provides acceleration for FICON tape write
operations over FCIP for the IBM Virtual Tape
Server (VTS) and tape libraries that support the
3490 command set.
Allows users to simulate network conditions to
test the impact of network latency for FCIP or
iSCSI.
Provides default support for Fibre Channel ACL
adjacency sharing on Generation 2 switching
modules.
Allows remote users to configure command
scheduler jobs.
Increases the limits for IVR zones to 8000 and for
IVR zone members to 20,000
Allows you to specify a server to receive
Registered Link Incident Report (RLIR) frames.
Sets the maximum number of users on a switch to
256.
Allows you to specify new options for the show
tech-support command for specific features.
Copies the SSI boot image file to the SSM
modflash:.
Allows the domain manager to quickly recover
from a principal link failure when a backup link
is available.
Allows you to change the default setting for port
prohibiting.
Includes the following CLI enhancements:
User-defined command variables.
•
User-defined aliases for common commands.
•
• The pwc command displays the list of
commands entered to reach a command
submode.
Command variable support in the run-script
•
command.
New and Changed Information
Changed
in
Release Where Documented
3.1(1) Chapter 14, "Configuring
Generation 2 Switches and
Modules"
3.1(1) Chapter 28, "Configuring FICON"
3.1(1) Chapter 58, "Troubleshooting Your
Fabric"
3.0(3) Chapter 14, "Configuring
Generation 2 Switches and
Modules"
3.0(3) Chapter 18, "Scheduling
Maintenance Jobs"
3.0(3) Chapter 22, "Configuring
Inter-VSAN Routing"
3.0(3) Chapter 28, "Configuring FICON"
3.0(3) Chapter 39, "Configuring Users
and Common Roles"
3.0(3) Chapter 58, "Troubleshooting Your
Fabric"
3.0(2) Chapter 11, "Managing Modules"
3.0(2) Chapter 17, "Configuring Domain
Parameters"
3.0(2) Chapter 28, "Configuring FICON"
3.0(1) Chapter 2, "Before You Begin"
OL-16184-01, Cisco MDS SAN-OS Release 3.x