Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
:
Command
Step 1
switch(config-profile)# tcp
send-buffer-size 5000
switch(config-profile)# no tcp
send-buffer-size 5000
Displaying FCIP Profile Configuration Information
Use the show fcip profile command to display FCIP profile configuration information.
switch# show fcip profile 7
FCIP Profile 7
Advanced FCIP Interface Configuration
This section describes the options you can configure on an FCIP interface to establish connection to a
peer and includes the following topics:
•
•
•
•
•
•
To establish a peer connection, you must first create the FCIP interface and enter the
submode.
To enter the
Command
Step 1
switch# config terminal
Step 2
switch(config)# interface fcip 100
Configuring Peers
To establish an FCIP link with the peer, you can use one of two options:
Cisco MDS 9000 Family CLI Configuration Guide
40-18
Internet Address is 47.1.1.2 (interface GigabitEthernet4/7)
Listen Port is 3225
TCP parameters
SACK is disabled
PMTU discovery is enabled, reset timeout is 3600 sec
Keep alive is 60 sec
Minimum retransmission timeout is 300 ms
Maximum number of re-transmissions is 4
Send buffer size is 0 KB
Maximum allowed bandwidth is 1000000 kbps
Minimum available bandwidth is 15000 kbps
Estimated round trip time is 1000 usec
Configuring Peers, page 40-18
Active Connections, page 40-20
Number of TCP Connections, page 40-20
Time Stamp Control, page 40-21
B Port Interoperability Mode, page 40-22
Quality of Service, page 40-24
submode, follow these steps:
config-if
Purpose
Configure the advertised buffer size to 5000 KB. The valid
range is from 0 to 16384 KB.
Reverts the switch to its factory default. The default is 0 KB.
Purpose
Enters configuration mode.
Creates an FCIP interface (100).
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 40
Configuring FCIP
config-if