Mapping Of Cli Operations To Snmp - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 39 Configuring Users and Common Roles
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 39-1
Switch 1
Each role in SNMP is the same as a role created or modified through the CLI (see the
Authorization" section on page
Each role can be restricted to one or more VSANs as required.
You can create new roles or modify existing roles using SNMP or the CLI.
•
•

Mapping of CLI Operations to SNMP

SNMP has only three possible operations: GET, SET, and NOTIFY. The CLI has five possible
operations: DEBUG, SHOW, CONFIG, CLEAR, and EXEC.
NOTIFY does not have any restrictions like the syslog messages in the CLI.
Note
Table 39-1
Table 39-1
CLI Operation
DEBUG
SHOW
CONFIG
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Common Roles
Common Roles
Role: network admin
Description: Predefined network admin
access to all the switch commands
Role: network-operator
Description: Predefined network operation
access to show commands and selected E
Role: sangroup
Description: SAN management group
Rule Type Command-type
1. permit config
2. deny config
3. permit debug
4. permit
exec
SNMP—Use the CISCO-COMMON-ROLES-MIB to configure or modify roles. Refer to the Cisco
MDS 9000 Family MIB Quick Reference.
CLI—Use the role name command.
explains how the CLI operations are mapped to the SNMP operations.
CLI Operation to SNMP Operation Mapping
Features
*
fspf
zone
fcping
39-1).
SNMP Operation
Ignored
GET
SET
Cisco MDS 9000 Family CLI Configuration Guide
Configuring Common Roles
CLI
SNMP
"Role-Based
39-9