S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 1-1
New and Changed Features for Release 3.x (continued)
Feature
Dynamic initiator modes
IPv6
RMON high capacity
alarms
Call Home enhancement
QoS behavior
On-line system health
maintenance (OHMS)
enhancements
On-board failure logging
(OBFL)
Cisco MDS 9000 Family CLI Configuration Guide
lx
Description
Allows configuration of dynamic initiator modes
iSCSI, iSLB, and deny log in to the MDS switch.
Provides support for IP version 6 (IPv6).
Provides the show rmon high capacity alarms
command to display RMON high capacity alarm
values.
Allows customization of alert group messages.
Provides information about the behavior of QoS
with different combinations of Generation 1 and
Generation 2 switching modules.
Includes the following OHMS enhancements:
•
Configuring the global frame length for
loopback test for all modules on the switch.
Specifying frame count and frame length on
•
for the loopback test on a specific module.
Configuring source and destination ports for
•
external loopback tests.
Providing serdes loopback test to check
•
hardware.
Describes OBFL, how to configure it for
Generation 2 modules, and how to display the log
information.
New and Changed Information
Changed
in
Release
Where Documented
3.0(1)
Chapter 42, "Configuring iSCSI"
3.0(1)
Chapter 43, "Configuring IP
Services"
Chapter 46, "Configuring IPv6 for
Gigabit Ethernet Interfaces"
3.0(1)
Chapter 51, "Configuring RMON"
3.0(1)
Chapter 54, "Configuring Call
Home"
3.0(1)
Chapter 56, "Configuring Fabric
Congestion Control and QoS"
3.0(1)
Chapter 59, "Monitoring System
Processes and Logs"
3.0(1)
Chapter 59, "Monitoring System
Processes and Logs"
OL-16184-01, Cisco MDS SAN-OS Release 3.x