Identifying Module LEDs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
1. The speed LED is only present on the 2-Gbps Fibre Channel switching modules.
Cisco MDS 9000 Family CLI Configuration Guide
LEDs for the Cisco MDS 9200 Series Supervisor Modules (continued)
Solid green Link is up.
Link is disabled by software.
A fault condition exists.
describes the LEDs for the Cisco MDS 9200 Series interface module.
LEDs on the Cisco MDS 9200 Series Interface Module
All diagnostics pass. The module is operational (normal initialization
Orange The module is booting or running diagnostics (normal initialization
The inlet air temperature of the system has exceeded the maximum system
operating temperature limit (a minor environmental warning). To ensure
maximum product life, you should immediately correct the environmental
temperature and restore the system to normal operation.
The diagnostic test failed. The module is not operational because a fault
occurred during the initialization sequence.
he inlet air temperature of the system has exceeded the safe operating
temperature limits of the card (a major environmental warning). The card
has been shut down to prevent permanent damage.
All chassis environmental monitors are reporting OK.
Orange The power supply failed or the power supply fan failed.
Incompatible power supplies are installed.
The redundant clock failed.
The temperature of the supervisor module exceeded the major threshold.
Link is up.
Traffic is flowing through port.
No link or no traffic.
OL-16184-01, Cisco MDS SAN-OS Release 3.x