HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 57

New and Changed Information
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 1-1 New and Changed Features for Release 3.x (continued)
Feature
Configuration format
change
Supervisor-2 module
support
CFS over IP
Configuration check
Supervisor module
management procedures
boot auto-copy
command enabled by
default
Crossbar removal
procedures
N-port identifier
virtualization (NPIV)
Auto port mode support
change
Generation 2 switching
module support
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Description
Describes the multiple entry format for
displaying interface configuration information in
the show running-config and show
startup-config command outputs.
Includes support for the following Supervisor-2
module features:
Configuring modem parameters on the
•
console port and COM1 port.
Allowing 1000 Mbps speed on the
•
management port.
Allows CFS distributions over IP connections.
Describes the changes to the show
incompatibility system command that indicate
the commands to use to disable features before
downgrading to an earlier release of the system
image.
Includes the following recommended supervisor
module management procedures:
• Preparing to remove supervisor modules
from Cisco MDS 9500 Series Directors
containing both Generation 1 and
Generation 2 switching modules.
Migrating from Supervisor-1 modules to
•
Supervisor-2 modules in the Cisco MDS
9500 Series Directors.
Changes the default state for the boot auto-copy
command to enabled.
Provides the recommended procedures to prepare
to remove crossbars from Cisco MDS 9500 Series
Directors.
Provides support for multiple N port identifiers to
support multiple applications on a server
accessing an MDS switch.
Disallows configuring auto port mode on Storage
Services Module (SSM) Fibre Channel interfaces.
Describes how to configure interfaces on the
Generation 2 Fibre Channel switching modules.
Changed
in
Release Where Documented
3.0(1) Chapter 2, "Before You Begin"
Chapter 12, "Configuring
Interfaces"
3.0(1) Chapter 5, "Initial Configuration"
3.0(1) Chapter 6, "Using the CFS
Infrastructure"
3.0(1) Chapter 7, "Software Images"
3.0(1) Chapter 7, "Software Images"
3.0(1) Chapter 9, "Configuring High
Availability"
3.0(1) Chapter 10, "Managing System
Hardware"
3.0(1) Chapter 12, "Configuring
Interfaces"
3.0(1) Chapter 12, "Configuring
Interfaces"
3.0(1) Chapter 14, "Configuring
Generation 2 Switches and
Modules"
Cisco MDS 9000 Family CLI Configuration Guide
lvii