Example Configurations; Configuring A 24-Port 4-Gbps Fibre Channel Switching Module Example - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Example Configurations

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
...
Example Configurations
This section describes example configurations and includes the following sections:
•
•

Configuring a 24-port 4-Gbps Fibre Channel Switching Module Example

This section describes how to configure the example shown in
Step 1 Select interfaces fc 3/1 through fc 3/3.
switch# config t
switch(config)# interface fc 3/1 - 3
Configure the port speed, rate mode, and port mode on the interfaces.
Step 2
switch(config-if)# switchport speed 4000
switch(config-if)# switchport rate-mode dedicated
switch(config-if)# switchport mode e
Enable the interfaces and return to configuration mode.
Step 3
switch(config-if)# no shutdown
switch(config-if)# exit
switch#
Step 4 Select the interfaces fc 3/4 through fc 3/6.
switch# config t
switch(config)# interface fc 3/4 - 6
Configure the port speed, rate mode, and port mode on the interfaces.
Step 5
switch(config-if)# switchport speed 1000
switch(config-if)# switchport rate-mode shared
switch(config-if)# switchport mode f
Enable the interfaces and return to configuration mode.
Step 6
switch(config-if)# no shutdown
switch(config-if)# exit
Cisco MDS 9000 Family CLI Configuration Guide
14-36
Nominal bit rate is 2100 MBits/sec
Link length supported for 50/125mm fiber is 300 m(s)
Link length supported for 62.5/125mm fiber is 150 m(s)
cisco extended id is unknown (0x0)
no tx fault, rx loss, no sync exists, Diag mon type 104
SFP Diagnostics Information
Temperature :
Voltage :
Current :
Optical Tx Power :
Optical Rx Power :
Note: ++ high-alarm; +
Configuring a 24-port 4-Gbps Fibre Channel Switching Module Example, page 14-36
Configuring a 48-port 4-Gbps Fibre Channel Switching Module Example, page 14-37
Chapter 14
24.33 Celsius
3.33 Volt
0.04 mA --
N/A dBm --
N/A dBm -
high-warning; -- low-alarm; -
Configuring Generation 2 Switches and Modules
low-warning
Figure 14-5 on page 14-12.
OL-16184-01, Cisco MDS SAN-OS Release 3.x