Enabling Cfs Over Ip - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

CFS Distribution over IP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 6-2
Node A
Figure 6-3
C and node D forward the event to E because the node E is not in the distribution list from node B.
Figure 6-3
Node A

Enabling CFS Over IP

To enable or disable CFS over IPv4, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# cfs ipv4 distribute
switch(config)# no cfs ipv4 distribute
This will prevent CFS from distributing
over IPv4 network.
Are you sure? (y/n) [n] y
To enable or disable CFS over IPv6, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# cfs ipv6 distribute
switch(config)# no cfs ipv6 distribute
Cisco MDS 9000 Family CLI Configuration Guide
6-12
Network Example 2 with Fibre Channel and IP Connections
Node B
FC
IP
is the same as Figure 6-2
Network Example 3 with Fibre Channel and IP Connections
Node B
FC
IP
Node C
Node D
except that node D and node E are connected using IP. Both node
Node C
Node D
Purpose
Enters configuration mode.
Globally enables CFS over IPv4 for all applications
on the switch.
Disables (default) CFS over IPv4 on the switch.
Purpose
Enters configuration mode.
Globally enables CFS over IPv6 for all applications
on the switch.
Disables (default) CFS over IPv6 on the switch.
Chapter 6 Using the CFS Infrastructure
Node E
Node E
OL-16184-01, Cisco MDS SAN-OS Release 3.x