HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 969

Chapter 40 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 4
switch1(config-if)# peer-info ipaddr 10.1.1.1
Step 5
switch1(config-if)# no shutdown
To create an FCIP link endpoint in switch 2, follow these steps:
Command
Step 1
switch2# config terminal
switch(config)#
Step 2
switch2(config)# interface fcip 52
switch2(config-if)#
Step 3
switch2(config-if)# use-profile 20
Step 4
switch2(config-if)# peer-info ip
address 10.100.1.25
Step 5
switch1(config-if)# no shutdown
To create FCIP link endpoint in switch 1, follow these steps:
Command
Step 1
switch1# config terminal
switch(config)#
Step 2
switch1(config)# interface fcip 51
switch1(config-if)#
Step 3
switch1(config-if)# use-profile 10
Step 4
switch1(config-if)# peer-info ipaddr 10.1.1.1
Step 5
switch1(config-if)# no shutdown
To create an FCIP link endpoint in switch 2, follow these steps:
Command
Step 1
switch2# config terminal
switch(config)#
Step 2
switch2(config)# interface fcip 52
switch2(config-if)#
Step 3
switch2(config-if)# use-profile 20
Step 4
switch2(config-if)# peer-info ip
address 10.100.1.25
Step 5
switch1(config-if)# no shutdown
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Purpose
Assigns the peer IPv4 address information
(10.1.1.1 for switch 2) to the FCIP interface.
Enables the interface.
Purpose
Enters configuration mode.
Creates an FCIP interface (52).
Binds the profile (20) to the FCIP interface.
Assigns the peer IPv4 address information (10.100.1.25
for switch 1) to the FCIP interface.
Enables the interface.
Purpose
Enters configuration mode.
Creates an FCIP interface (51).
Assigns the profile (10) to the FCIP interface.
Assigns the peer IPv4 address information
(10.1.1.1 for switch 2) to the FCIP interface.
Enables the interface.
Purpose
Enters configuration mode.
Creates an FCIP interface (52).
Binds the profile (20) to the FCIP interface.
Assigns the peer IPv4 address information (10.100.1.25
for switch 1) to the FCIP interface.
Enables the interface.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring FCIP
40-11