Dhcp Server Manual Binding - D-Link DGS-3612G - xStack Switch Reference Manual

DHCP Server Manual Binding

The following windows will allow users to view and set manual DHCP entries. Manual DHCP entries will bind an IP address with
the MAC address of a client within a DHCP pool. These entries are necessary for special devices on the local network that will
always require a static IP address that cannot be changed.
To view this window, click L3 Features > DHCP Server > DHCP Server Manual Binding, as shown below:
Users may view statically bound DHCP entries within a DHCP pool by entering the Pool Name and clicking Find. Results will be
displayed in the window above. To remove an entry from the table, click its corresponding
To set a manual DHCP Binding entry, click the Add window, which will produce the following window to configure.
The following parameters may be configured or viewed.
Parameter Description
Pool Name Enter the name of the DHCP pool within which will be created a manual DHCP binding entry.
IP Address Enter the IP address to be statically bound to a device within the local network that will be specified
by entering the Hardware Address in the following field.
Hardware Enter the MAC address of the client to be statically bound to the IP address entered in the previous
Address field.
Type This field is used to specify the type of connection for which this manually bound entry will be set.
Ethernet will denote that the manually bound device is connected directly to the Switch, while the
IEEE802 denotes that the manually bound device is outside the local network of the Switch.
Click Apply to set the entry.
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 4- 81. DHCP Server Manual Binding Table window
Figure 4- 82. Create DHCP Pool Manual Binding window
238
under the Delete heading.