D-Link DGS-3612G - xStack Switch Reference Manual page 118

Access Ports These are the ports that are set as access ports on the Switch. Access ports are for connecting
Switch VLANs to customer VLANs. Gigabit ports cannot be configured as access ports.
Unknown Ports These are the ports that are a part of the VLAN but have yet to be defined as Access or Uplink
ports.
To create a Double VLAN, click the Add button, revealing the following window for the user to configure.
To create a Double VLAN, enter the following parameters and click Apply.
Parameter Description
VLAN Name Enter the pre-configured VLAN name to create as a Double VLAN.
SPVID Enter the VID for the Service Provider VLAN with an integer between 1 and 4094.
TPID Enter the TPID in hex form to aid in packet identification of the Service Provider VLAN.
Click Apply to implement changes made.
To configure the parameters for a previously created Service Provider VLAN, click the
in the Double VLAN Table. The following window will appear for the user to configure.
To configure a Double VLAN, enter the following parameters and click Apply.
Parameter Description
VLAN Name The name of the pre-configured VLAN name to be configured.
TPID (0x0-0xffff) The tagged protocol ID. Enter the new TPID in hex form to aid in packet identification of the
Service Provider VLAN.
Operation Allows one of the following three acts to be performed:
Add Ports – Will allow users to add ports to this Service Provider VLAN using the Port List field
below.
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 3- 13. Double VLAN Creation window
Figure 3- 14. Double VLAN Configuration window
102
button of the corresponding SPVID