Snmp Trap Settings - D-Link DGS-3612G - xStack Switch Reference Manual

®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch

SNMP Trap Settings

The following window is used to enable and disable trap settings for the SNMP function on the Switch.
To view this window for configuration, click Administration > SNMP Manager > SNMP Trap Settings, as shown below:
Figure 2- 66. SNMP Trap Settings window
To enable or disable the Traps State, Authenticate Trap State, and/or Linkchange Trap State use the corresponding pull-down
menu to change and click Apply.
To enable or disable linkchange trap settings for individual ports, select the ports using the From and To drop-down menus, enable
State using the drop-down menu, and then click Apply.
63