D-Link DGS-3612G - xStack Switch Reference Manual page 328

Select UDP to use the IPv6 UDP port number contained in an incoming packet as the
forwarding criterion. Selecting IPv6 UDP requires that you specify a source port mask and/or a
destination port mask.
dst port mask - Specify a IPv6 UDP port mask for the destination port in hex form (hex 0x0-
0xffff)
Click Apply to implement changes made.
To view the configurations set for a previously created access profile, return to the Access Profile Table and click the
under the Display heading, corresponding to the access profile for which to view configurations. A window similar to the one
below will be displayed.
To establish the rule for a previously created Access Profile:
To view this window, click ACL > Access Profile Table, as shown below:
To create a new rule set for an access profile click the Modify button located under the Access Rule heading. The window shown
below (Access Profile Rule) will be displayed. To remove a previously created rule, click the corresponding
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
0x0-0xffff) which you wish to filter.
src port mask - Specify a IPv6 UDP port mask for the source port in hex form (hex 0x0-
0xffff).
Figure 6- 7. Access Profile Entry Display window (Ethernet)
Figure 6- 8. Access Profile Table window
312
button
button.