Dhcp Server Manual Binding; Dhcp Server Dynamic Binding - D-Link DGS-3620-52P Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
NetBIOS Name Server
Default Router
Pool Lease
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.

DHCP Server Manual Binding

An address binding is a mapping between the IP address and MAC address of a client. The IP address of a client
can be assigned manually by an administrator or assigned automatically from a pool by a DHCP server. The
dynamic binding entry will be created when an IP address is assigned to the client from the pool network's address.
To view this window, click Network Application > DHCP > DHCP Server > DHCP Server Manual Binding as
shown below:
The fields that can be configured are described below:
Parameter
Pool Name
IP Address
Hardware Address
Type
Click the Add button to add a new entry based on the information entered.
Click the Delete All button to remove all the entries listed.
Click the Delete button to remove the specific entry.

DHCP Server Dynamic Binding

This window is used to delete the DHCP server dynamic binding table.
to a DHCP client. Up to three IP addresses can be specified in one command line.
IP address of WINS server. Windows Internet Naming Service (WINS) is a name
resolution service that Microsoft DHCP clients use to correlate host names to IP
addresses within a general grouping of networks. Up to three IP addresses can be
specified in one command line.
IP address of default router. Specifies the IP address of the default router for a DHCP
client. Up to three IP addresses can be specified in one command line.
By default, each IP address assigned by a DHCP server comes with a one-day lease,
which is the amount of time that the address is valid. Tick the Infinite check box to
have infinite lease.
Days – Days of lease.
Hours – Hours of lease.
Minutes – Minutes of lease
Figure 9-12 DHCP Server Manual Binding Window
Description
Enter the DHCP Server Pool name.
IP address which will be assigned to specified client.
Enter the hardware address.
Either Ethernet or IEEE802 can be specified.
394