Radius Accounting Settings - D-Link DGS-3612G - xStack Switch Reference Manual

RADIUS Accounting Settings

The Accounting feature of the Switch uses a remote RADIUS server to collect information regarding events occurring on the
Switch. The following is a list of information that will be sent to the RADIUS server when an event triggers the Switch to send
these informational packets. Account Session ID
•
Account Status Type
•
Account Terminate Cause
•
Account Authentic
•
Account Delay Time
•
Account Session Time
•
Username
•
Service Type
•
NAS IP Address
•
NAS Identifier
•
Calling Station ID
There are three types of Accounting that can be enabled on the Switch.
Network – When enabled, the Switch will send informational packets to a remote RADIUS server when 802.1X users connect to
the physical ports on the switch to access the network. Network accounting only works when 802.1X is enabled
Shell – When enabled, the Switch will send informational packets to a remote RADIUS server when a user either logs in, logs out
or times out on the Switch, using the console, Telnet, or SSH.
System – When enabled, the Switch will send informational packets to a remote RADIUS server when system events occur on the
Switch, such as a system reset or system boot.
Remember, this feature will not work properly unless a RADIUS Server has first been configured. This RADIUS server will
format, store and manage the information collected here.
To view this window, click Security > Access Authentication Control > RADIUS Accounting Settings, as shown below:
®
xStack DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 7- 58. RADIUS Accounting Settings window
389